Pay attention to the inner structure of metal shredder

The metal shredder completely tears the scrap metal that falls into the crushing chamber through the drilling blade, so that the metal is finely broken into particles to meet the requirements. At the outlet of the metal shredder, material sorting is also installed. Therefore, when using a metal shredder for production operations, the size of the gap between the blade and the screen and the size of the bottom hole of the screen should be reasonably adjusted according to the specific needs of the production to ensure that the production equipment meets the requirements of the finished product.

Through the bottom gap control, when the gap between the blade of the metal shredder and the bottom of the screen is too large and the hammer head and the bottom of the screen and the bottom of the screen are large in diameter, it is suitable for coarsely crushed materials; producing spherical metal. The mass diameter is larger and vice versa is suitable for fine crushing. If the gap and the size of the bottom hole diameter are exceeded in a specific production, it will have an adverse effect on production. When the material is required to be coarsely broken, if the diameter of the bottom hole meets the production requirements of the equipment, but the gap between the blade and the bottom of the screen is too small, it is easy to cause the material to be stuck on the screen, resulting in damage to the bottom of the screen; When the gap is too large, if the diameter of the bottom hole is too small, the feed of the metal shredder will be stuck, even if it is serious, the motor will burn out, resulting in production stagnation.

When scrap metal needs to be finely crushed for production, if the diameter of the bottom hole of the metal shredder meets the requirements, but the gap between the plug-in and the bottom of the screen is large, it will also cause difficulty in feeding and even burn out the motor; If the bottom diameter is too large and the gap between the bottom of the screen and the bottom of the hammer is too small, the metal shredder does not meet the production design requirements, and the size of the finished product does not meet the production requirements, resulting in waste of equipment and materials. Therefore, in the actual operation of production, the internal structure of the metal shredder should be appropriately adjusted according to production needs to ensure that the equipment is in a good operating environment and maintain high-efficiency production capacity.

Henan Honest Heavy Machinery : http://www.honestshredder.com/，All rights reserved。