Treatment method of equipment blockage failure of metal shredder

In the production of metal shredder equipment, clogging is a problem that the operation is afraid of encountering, because it is light, we need a little time to repair it, and the heavy one may jam the blade of the equipment and repair it. It is very troublesome, but the blockage of the metal shredder equipment is a problem that often occurs. Although a lot of time is just a simple process, it is very troublesome. To solve this problem, many customers will learn many preventive methods to minimize the occurrence of clogging. If the metal shredder equipment has been clogged, how should we solve it in time so that it will not cause more trouble to our production? The following is provided by the shredder manufacturer:

First of all, if we find that there are few blockages during production, we must first reduce the blanking, first remove the blockages, and see if it is because there are materials that are not suitable for shredding, and then check whether the blades are worn , If everything is ruled out, start production again.

Secondly, it is ruled out that there will still be clogging during production afterwards. We need to see if our feeding speed is too fast. If the feeding speed is too fast, we need to adjust the feeding speed to solve the material well. The problem of clogging.

If the blockage cannot be eliminated during production, you must shut down the machine in time. You can turn on the material blockage and damage the tool, and then check whether the distance between the blades is adjusted in place, and whether the blade is installed whole.

After the above inspection and treatment, the blockage of the metal shredder equipment can be solved very well. Of course, if the blockage problem occurs as less as possible, the better.

Henan Honest Heavy Machinery : http://www.honestshredder.com/，All rights reserved。