How to disassemble and install the double shaft shredder blade

Under normal circumstances, after the double shaft shredder has been used for a long time, the shredder blade needs to be replaced and maintained, so how to disassemble and install the double shaft shredder blade has become a headache for many staff, and replacing the shredder blade. There are roughly four steps. The following is a detailed introduction to the shredder blade replacement process:

1. First, we disassemble the shredding box of the shredder and put it on the flat ground to ensure stability.

2. Remove the sealing ring of the tool box and disassemble the two complete tool shafts. Due to its heavy weight, it can be fastened with a sling and lifted out with a crane or a forklift.

3. Then, find the other end of the cutter shaft where the pulley is installed.

4. When the combination of the blade and the shaft is relatively strong, it is better to use a hammer first, add a wood backing plate to the blade and smash it lightly. If it still cannot move, you need to use a puller to disassemble and find the damaged blade. Replace it and install it as it is.

Shredder tool repair skills

1. The easiest way to grind is to use a wire cutting machine to polish the inside of the edge until the edge of the blade is sharp.

2. The plane of the blade is vertical, so that the loss of the original blade body will be minimal.

3. After completing the above steps, the shredder blade can be used again.

Henan Honest Heavy Machinery : http://www.honestshredder.com/，All rights reserved。