Installation process of the metal shredder equipment

Metal shredder is a common equipment for processing waste aluminum. The material processed by the metal shredder can enter the crusher and eddy current equipment for further processing. Common processing materials include paint buckets, light and thin materials, refrigerators, Cars, scrap steel, car shells, metal scraps, etc. So what is the installation process of the metal shredder equipment, today we will take you to introduce the equipment process in detail.

1. Key points for the installation of metal shredder rack components:

a: Metal shredder equipment is a device that uses knives to shred materials. During production, due to the large vibration of the operation, some cushions can be placed between the cement foundation and the frame, such as rubber as vibration buffering materials. . After installation, check the levelness of the rack, and the deviation must be controlled below 2mm. Some customers install the host of the metal shredder by digging a pit. Whether it is ground installation or digging anti-installation, it is more convenient.

b: There is no anchor bolt installation method. The good operation balance of the metal shredder equipment makes the crusher work normally without the installation of anchor bolts. The rubber damping block installed at the bottom of the crusher support can absorb the shock peak load, thereby reducing the impact force of the crusher on the foundation.

c: The metal shredder should be fixed on the cement base. If the workplace is often changed, the shredder and motor should be installed on a base made of angle iron to prevent the metal shredder from being damaged by moving back and forth.

2. Key points of horizontal parallel installation process

After the host components of the metal shredder equipment are installed, other equipment can be installed. Usually, it can be installed in a movable way. Install the crusher and the motor on the base made of I-shaped steel. The pulley groove of the main machine and the pulley of the motor should be consistent, and the outer end surface of the pulley should be on the same plane. In this case There is a basis for activities. When loading, you should stand on one side of the shredder or choose a conveyor to load to prevent the rebounding fragments from hurting the face. Do not close it immediately after the work is over, and run idly for 2-3 minutes to completely discharge the materials in the machine.

3. After the metal shredder is installed, it is necessary to check whether the parts and equipment and the machine base are firmly fixed. If the installation is not firm, vibration will occur. If things go on like this, the vibration will become more and more severe and the noise will become louder. Therefore, we should pay attention to the fixing of each part during installation. After the installation is completed, we must test and debug the metal shredder. The simple method is to let the machine idle for a few minutes. If there is no abnormal situation, it means that the installation has been successful. The user needs to pay more attention to understand the abnormal situation, and prepare for self-debugging in the future.

Henan Honest Heavy Machinery : http://www.honestshredder.com/，All rights reserved。