The common faults and solution for the metal shredder

The metal shredder is a kind of equipment used to process scrap metal. The common faults are as follows:

Blade wear: After the shredder is used for a long time, the blade will wear out, reducing the shredding efficiency and even affecting the life of the equipment. Blades need to be replaced periodically.

Motor failure: The motor is the core component of the shredder. Once the motor fails, the equipment cannot work normally. The motor needs to be repaired or replaced in time.

Overload: When the shredder processes too much or too heavy metal, it will cause the equipment to be overloaded and even cause equipment damage. Feed volume needs to be controlled to avoid overloading.

Frame deformation: After using the shredder for a long time, the frame may be deformed, resulting in equipment imbalance or increased noise. The rack needs to be adjusted or replaced in time.

Oil pump failure: The shredder needs to be lubricated regularly. If the oil pump fails, it will cause the equipment to run poorly or even get stuck. The oil pump needs to be repaired or replaced in time.

Solution:

Replacing blades: Regularly check blade wear and replace worn blades in time.

Repair or replace the motor: For motor failure, you need to find a professional technician to repair or replace it.

Control the feeding amount: Reasonably control the feeding amount to avoid overload and ensure the normal operation of the equipment.

Adjust or replace the rack: When the rack is found to be deformed, it is necessary to adjust or replace the rack in time to ensure the stability of the equipment.

Repair or replace the oil pump: Regularly check whether the oil pump is operating normally, and if any fault is found, it is necessary to repair or replace the oil pump in time.

Henan Honest Heavy Machinery : http://www.honestshredder.com/，All rights reserved。