How to do a good job of lubrication for wood shredder

The lubrication work of the waste wood shredder is very important, and this detail can directly affect the service life of the equipment. If the equipment is well lubricated, it can not only prolong the service life, but also improve the operating rate of the shredder, reduce the occurrence of failures, and facilitate the smooth progress of production. Let's take a look at how to do a good job of lubrication.

1. Lubricate the friction surface regularly, so as to ensure the stable operation of the machine and prolong the service life of the machine. Therefore, add an appropriate amount of grease after the waste wood shredder has been running for 400 hours; after 2000 hours, the main shaft assembly and bearings need to be cleaned; after 7200 hours, it will be replaced with new bearings. However, if the bearings are well maintained, the service life can also be extended.

Second, before the operation of the waste wood shredder, lubricating grease should be added to the contact between the toggle plate and the toggle pad; the amount of lubricating oil added to the bearing seat should be five-tenths to tenths of the volume Seven, the lubricating oil needs to be replaced once every 3 to 6 months. When replacing the waste wood shredder, it is necessary to use clean gasoline or kerosene to clean the raceway of the bearing, and then wait until it is clean before replacing it with new lubricating oil.

Third, bearings generally need to use a butter cup to refuel, basically every hour or so. Add engine oil to the toggle plate and add it every half a day.

4. If the winter environment is relatively cold, you can add less thick lubricating oil to avoid the problem of solidification. After adding, you must do a good job of sealing to avoid impurities from entering and affecting the lubrication effect.

Henan Honest Heavy Machinery : http://www.honestshredder.com/，All rights reserved。