Installation method and skills of reducer in double shaft shredder

The reducer has a large reduction ratio, high transmission efficiency, small size, light weight, few failures, long life, stable and reliable operation, low noise, convenient disassembly and assembly, easy maintenance, simple structure, strong overload capacity, impact resistance, and small moment of inertia ,Features. Therefore, the shredder technicians were successfully introduced into the shredder and production line to ensure the smooth operation of the equipment.

The installation method of the reducer in the shredder is as follows:

Step 1: Before installation, confirm whether the motor and reducer are intact, and strictly check whether the dimensions of the parts connecting the motor and the reducer are matched. Here are the dimensions and tolerances of the positioning boss of the motor, the input shaft and the groove of the reducer.

Step 2: Unscrew the screw on the dust-proof hole on the outer side of the reducer flange, adjust the PCS system clamping ring to align the side hole with the dust-proof hole, and insert the inner hexagon to tighten. After that, remove the motor shaft key.

Step 3: Connect the motor and the reducer naturally. When connecting, it must be ensured that the concentricity of the output shaft of the reducer and the input shaft of the motor is the same, and the outer flanges of the two are parallel. If the center is inconsistent, it will cause the motor shaft to break or the gear of the reducer to wear.

Since the shredder will run at high temperature for a long time, you must pay attention to the working conditions of each main component during use. If there is a problem, please stop it in time.

Henan Honest Heavy Machinery : http://www.honestshredder.com/，All rights reserved。