How should we maintain the blade during wood shredder use?

For wood shredders, the selection method of the blade directly determines the service life of the blade. In terms of the material of the blade, the selection criteria for different materials are often different, such as crushed wood, metal, plastic and other materials in the blade material. 9crsi, D20 or cr12mov can be considered in the selection. If the equipment is short of the selection problem, how should we maintain the blade during use?

When we feed the material to the feeding port, we must check whether there is any scrap metal or other hard materials in the shredded material. If there is, it should be cleaned immediately to avoid the chipping of the wood shredder blade when shredding, and check whether there are any blades that are about to fall off in the wood shredder blade set before leaving get off work every day. If there is, it must be replaced in time. Because the blades are damaged, you don't know when they will fall off. If they fall off in the material box, it will cause the entire set of blades to be reimbursed.

Before use, first check whether the rotor of the blade is flexible and reliable, and then turn the wheel by hand, whether the rotation direction of the wheel is consistent with the direction indicated by the machine arrow, whether there is any collision in the crushing chamber, the power machine and the blade of the wood shredder Whether the lubrication is good. During work, pay attention to the operation of the wood shredder blade at any time. If you find noise, vibration, excessive temperature of the bearing and the body, or spraying material outward, stop the machine for inspection in time. After the wood shredder is started, let it idle for two minutes to ensure that the motor starts normally. During the feeding process, it is necessary to keep it as uniform as possible to avoid excessive load on the equipment caused by centralized feeding.

If you can choose high-quality wood shredder blades for municipal waste that crushes metal, wood, and plastic mixtures, so as to achieve high standards of applicability to the above materials, and prevent low-quality blades from encountering metal or hard materials during use. The problem of severe wear and tear of high-quality materials.

Henan Honest Heavy Machinery : http://www.honestshredder.com/，All rights reserved。